세미나 및 이벤트
Design of table top machinery for 3D Microtooling and 3D Microstructuring
세미나 날짜
2006-05-22
작성자
임아주
작성일
2006-05-22
조회
1564
1. 제 목 : Design of table top machinery for 3D Microtooling and 3D Microstructuring
2. 연 사 : Dr. Hans Langen,( Assoc. prof., Advanced Mechatronics)
3. 일 시 : 2006년 5월 22일 (월) 오후 14시 00분 ~ 15시 00분
4. 장 소 : 301동 1512호 세미나실
5. 내 용 :
This talk presents the introduction of Delft Center for Mechatronics and Microsystems; Highlights in short on the collaboration between different departments at the Delft University of Technology (high precision equipment for optical disc mastering, dual stage drive)
Presented is the combinations of 3D microtooling and 3D microstructuring techniques using wire electrodischarge grinding (WEDG) and micro electrodischarge machining (EDM) in metal and spark assisted chemical engraving (SACE) in glass. The introduction to the microfactory project (started august 2005) describes a few projects aligned on a new-to-develop table top machine using a high speed spindle with active magnetic bearings.
6. 연사약력 :
Clusterleader of the Dutch Microfactory project within the MicroNed program
Delft University of Technology, Fac. of Mechanical, Maritime and Material Engineering, Dept. of Precision and Microsystems Engineering
MSc.-degree from University Twente (Netherlands, 1989), Mechanical Engineering: Mechatronics
Dr.-degree from University of Tokyo (Japan, 1994): Micromachining and micro assembly (EDM technology)
7. 문 의 : 기계항공공학부 주 종 남 교수 (☏ 880-7136)
2. 연 사 : Dr. Hans Langen,( Assoc. prof., Advanced Mechatronics)
3. 일 시 : 2006년 5월 22일 (월) 오후 14시 00분 ~ 15시 00분
4. 장 소 : 301동 1512호 세미나실
5. 내 용 :
This talk presents the introduction of Delft Center for Mechatronics and Microsystems; Highlights in short on the collaboration between different departments at the Delft University of Technology (high precision equipment for optical disc mastering, dual stage drive)
Presented is the combinations of 3D microtooling and 3D microstructuring techniques using wire electrodischarge grinding (WEDG) and micro electrodischarge machining (EDM) in metal and spark assisted chemical engraving (SACE) in glass. The introduction to the microfactory project (started august 2005) describes a few projects aligned on a new-to-develop table top machine using a high speed spindle with active magnetic bearings.
6. 연사약력 :
Clusterleader of the Dutch Microfactory project within the MicroNed program
Delft University of Technology, Fac. of Mechanical, Maritime and Material Engineering, Dept. of Precision and Microsystems Engineering
MSc.-degree from University Twente (Netherlands, 1989), Mechanical Engineering: Mechatronics
Dr.-degree from University of Tokyo (Japan, 1994): Micromachining and micro assembly (EDM technology)
7. 문 의 : 기계항공공학부 주 종 남 교수 (☏ 880-7136)
